MOW WITH EASE
FRONT SWIVEL CASTER WHEELS

Front swivel caster wheel model offers increased ease of manueverability in highly landscaped areas. Swivel wheel accessory also available to convert fixed wheel models.

FULLY FABRICATED AND WELDED STEEL CUTTER DECK
MILITARY-GRADE STEEL - DECK

Extra-strong fabricated (non-stamped) steel cutter deck features 14-gauge, grade 100 Military-Grade steel deck shell, 12-gauge spindle reinforcement plate and ¼" side reinforcement bar, all while delivering the quality-of-cut you'd expect from a Scag mower.

FULLY FABRICATED AND WELDED STEEL FRAME
MILITARY-GRADE STEEL - FRAME

Extra-strong, fully fabricated steel frame (not cast aluminum). The Military-Grade steel spec used on the SFC30 is over 200% stronger than standard drawing steel found in common stamped frames and decks in this machine class.

SINGLE POINT HEIGHT-OF-CUT ADJUSTMENT
FINE-TUNED AND SIMPLE

Adjust the height-of-cut from a single location rather than at all four corners or having to adjust the front and back tires separately. Refine your height settings with adjustments from 1.5" to 5" in .25" increments.

OFFSET BLADE SET UP
SIMPLIFIED DECK DRIVE SYSTEM

An offset blade design is less complex and easier to maintain than traditional timed deck setups. This more robust system results in potential belt replacements taking less than half the amount of time to repair/replace compared to timed deck systems. Image shown with bagging baffle.

SCAG LEVEL QUALITY-OF-CUT
UNMATCHED PERFORMANCE

The large cutting chamber helps process more grass while being able to eat through wet and lush spring time grasses more efficiently. Cutter deck discharge opening is oversized for its class.

OPERATOR CONTROL PANEL
ERGONOMIC CONTROLS

Angles of operator station controls match the natural angles of your outstretched hands. All controls are within easy reach: blade brake engagement, drive engagement, recoil start, throttle/choke, hour meter and park brake.

• Total Fuel Capacity
  1 gallon (0.37 gallon capacity for California models)
• Rear Tires
  10.5" x 3" rubber tire w/ glass-filled polypropylene wheel 
• Front Tires
  9" x 2.25" rubber tire w/ glass-filled polypropylene wheel
• Drive System Type
  GT MV 702 Transmission 
• Forward Ground Speed
  Up to 4 mph
• Parking Brake
  Hand lever
• Cutting Widths
  30"
• Type
  Extra-strong, fully fabricated and welded steel cutter deck. Offset blade, non-timed deck setup.
• Deck Lift
  Hand lever. Single-point adjustment.

• Cutting Height
  1.5" to 5" in .25" increments.
• Blade Type
  Optimized for maximum performance whether discharging, mulching or bagging
• Construction
  14-gauge, grade 100, Military Grade steel deck shell with 12-gauge spindle reinforcement plate. ¼" trim side reinforcement bar offers extra protection against impacts.
• Spindles
  Aluminum housing with sealed ball bearings.
• Blade Engagement
  Blade brake clutch allows operator to disengage cutter blades without shutting off the machine.
• Discharge, Mulch, Bag
  Standard
• Bag Capacity
  2.5 Bushels